Used EAW KF755 F - SB730 Subwoofer PA SET
Cod produs: Used EAW KF755 F - SB730 Subwoofer PA SET
Disponibilitate: disponibil in 8-10 zile
VAT Incl.
Descriere
Used EAW KF755 F - SB730 Subwoofer PA SET este un sistem complet de sonorizare compus din urmatoarele produse:
Component |
Nr buc |
EAW – KF755 F Downfill Array Loudspeaker, speaker pasiv 1200W, 140 dB |
8 |
EAW SB730 Subwoofer, 2 x 12”, subwoofer pasiv, 1200W
|
4 |
Presonus 802, digital mixer |
1 |
PL-Audio Power amplifier Rack , 10K 4 channel amplifier + 14K 2 channel amplifier + DSP speaker management processor + Power distributor + speaker signal distributor + rack case |
1 |
Sistemul este second-hand, toate speakerele au fost refurbisate si verificate, conditia lor fiind buna, lucrand in parametri. Toate speakerele sunt produse in USA si sunt importate din Europa. Rack-ul de amplificatoare este Made in Germany si se importa simultan cu speakerele. Conditia amplificatoarelor si a procesorului DSP este ”like NEW”, avand in continuare o garantie oferita de 3 ani!!!, iar mixerul digital Presonus 802 mai are inca o garantie de 1 an!, stare acestuia fiind ireprosabila.
Intreg sistemul poate fi adus si livrat integral in 8-10 zile, plata acestuia facandu-se integral anticipat.
Solutia de sonorizare propusa este ” la cheie”. Sub raportul calitate pret, acest impresionant sistem (care de nou ar costa de 3 ori mai mult), avand o putere de 14400 W RMS, la un SPL atingand lejer pragul de 140 dB, poate fi considerat realmente un ”DEAL”. De patru ori mai puternic ca un XA, sistemul va incanta nu numai prin forta, dar si prin claritate, gratie DSP-ului german care va separa foarte bine frecventele inainte de cele doua amplificatoare 4 x 2500 W, respectiv 2 x 7000W. Distributia speakerelor si a subwooferelor este urmatoarea: din amplificatorul PL- 10K cate 2 top-uri pe canal in paralel, iar din amplificatorul PL-14K, cate doua subwoofere in paralel pe canal, asigurandu-se astfel maximum de randament pe tot sistemul. Pentru evenimente outdoor/indoor cu pana la 2000 de persoane, acest setup este mai mult decat suficient. De remarcat este si fiabilitatea produselor. Un sistem care ”nu te lasa”!
Detalii tehnice (speakere si subwoofere):
EAW – KF755 F Downfill Array Loudspeaker x 8
SPECIFICATIONS KF755
The KF755F 3-way tri-amplified full range system is the down-
fill companion to the KF750F array module.
Since the large mid frequency horn contains both the high
and
low frequency subsystems, the overall package is just 31-in
high. Still, the KF755F provides consistent wideband pattern
control in both the vertical and horizontal planes.
The large MF horn loads a specially designed 10-in midrange
cone whose geometry exactly matches the rear of its phase
plug assembly. By developing the driver and phase plug as a
single unit, pathlength discontinuities within the MF pass-
band have been eliminated without compromising the direc-
tional qualities of the source as all previous phase plug
designs have.
The 2-in exit/4-in voice coil HF compression driver is mounted
on an asymmetrical 35° x 35° constant directivity horn
mounted coaxially within the MF horn flare. Vertical coverage
is 0° to -35°.
The KF755F’s 15°-per-side trapezoidal enclosure features
eight 4-position flytracks (four each front and rear) that
accept industry-standard flyclips.
The KF755F provides optimized downfill coverage below flown
arrays or, when inverted, provides upfill balcony coverage
from ground-stacked arrays when flying arrays are either not
allowed or not desired.
At just 31-in tall and under 200 pounds per module, KF700
Series arrays are smaller, lighter, more efficient and, therefore,
more powerful than those built with other systems. These
smaller, lighter arrays are easier to fly, require less truck space
and permit more open sight lines to cover any given venue.
The KF750F works with a companion downfill module, the
KF755F to provide full range nearfield coverage below the
array. The KF755F’s smooth power response produces remark-
ably even SPL levels throughout the coverage area, allowing
it to be used as a stand-alone system when necessary in
applications demanding that coverage pattern.
Applications include:
Concert Tours
Performing Arts Centers
Houses or Worship Theaters
Axial Sensitivity (dB SPL, 1 Watt @ 1m)
LF 99
MF 108
HF 115
Impedance (Ohms)
LF 8
MF 8
HF 8
Power Handling, (Watts Continuous)
LF 600
MF 400
HF 200
Recommended High-Pass Filter
24 dB/Octave 30 Hz
Calculated Maximum Output (dB SPL @ 1m)
LF Peak/Long Term 132/126
MF Peak/Long Term 140/134
HF Peak/Long Term 144/138
Nominal Coverage Angles, -6 dB points (degrees)
Horizontal 35
Vertical 35 (0 to -35)
PHYSICAL
Configuration 3-way, full range
Powering Tri-amplified
LF Subsystem 12-in cone, vented
MF Subsystem 10-in cone, Radial Phase Plug™
asymmetrically horn-loaded
HF Subsystem 2-in Exit/4-in voice coil
compression driver on
asymmetrical high Q horn
Coverage Angles 35° (h) x 35° (v, 0° to -35°)
Frequency Response (Hz)
±3 dB 48 Hz to 18 kHz
-10 dB 3
SB730 Subwoofer
Dual 12-in sub bass cones in a "clam shell" configuration, vented
FEATURES
•
Engineered to complement flown or stacked KF730 arrays
•
High output to size ratio from
custom-designed 12 in drivers
•
Extended response to 33 Hz
•
Integral lightweight fly hardware of 6061-T6 structural aluminum
DESCRIPTION
The SB730 is designed as a companion to KF730 Line Arrays,
but is suitable for other applications requiring high output at low
frequencies in a highly compact format. Used in arrays of two or
more, the SB730s couple to extend the low frequency response.
The unique enclosure shape both enhances the acoustical per-
formance and serves to provide a solid base for a
ground-stacked KF730 array. The SB730 enclosure is 1.5 times
the height of a KF730, which allows attractive KF730/SB730
arrays to be assembled in a 3:2 ratio.
The "clam shell" arrangment of its two, advanced design, 12
inch woofers provides tighter driver coupling to increase output
and maximize LF "punch". A massive port radiates the consider-
able energy needed at the enclosure's tuning frequency to com-
plement the KF730s output at other frequencies.
Several different wiring configurations are permitted. In addition
to Neutrik® NL4 input and loop-through connectors, an NL8
connector accepts amplifier outputs for both SB730s and
KF730s using a single amplifier rack cable. Additional SB730s
and KF730s are then daisy chained from one SB730. This
allows powering up to eight KF730s and four SB730s with just
four amplifier channels.
The enclosure features integral skids and companion recesses so
that enclosures interlock to stabilize stacked SB730s. Heavy duty
handles and an optional caster pallet facilitate transporting.
SUBWOOFER Single or Dual Amp
See TABULAR DATA notes for details
CONFIGURATION
Subsystem
Transducer
Loading
Sub 2x 12 in cone
Vented
Operating Mode
Amplifier Channels
External Signal Processing
Single-amp Sub 1/2
DSP w/1-way filter
Dual-amp Sub 1, Sub 2
DSP w/1-way filter
PERFORMANCE
1
Operating Range
33 Hz to 155 Hz
Nominal Beamwidth
Horz 360°
Vert 360°
Axial Sensitivity
(whole space SPL)
96 dB
33 Hz to 155 Hz
Peak Sensitivity
(whole space SPL)
104 dB
20 Hz to 20 kHz
Input Impedance
(ohms)
Nominal
Minimum
Sub1/2 4
4.5 @ 140 Hz
Sub 1, Sub 2 8, 8
9.0 @ 140 Hz
Recommended High Pass Filter
High Pass => 30 Hz, 12 dB/octave Butterworth
Accelerated Life Test
2
Sub1/2 69 V
1200 W @ 4 ohm
Sub 1, Sub 2 69 V, 69 V
600 W, 600W @ 8 ohm
Calculated Axial Output Limit
(whole space SPL)
Average
Peak
Sub 127 dB
133 dB
- Engineered to complement flown or stacked KF730 arrays
- High output to size ratio from custom-designed 12 in drivers
- Extended response to 33 Hz
- Integral lightweight fly hardware of 6061-T6 structural aluminum
KF755 F - SB730 Subwoofer
Opinii (0)
Spune-ţi opinia
Numele tău:Opinia ta: Notă: Codul HTML este citit ca şi text!
Nota: Rău Bun
Introduceţi codul din imagine: